Exmark Quest Service Manual (2024)

FAQs

How often should you change oil in Exmark zero turn mower? ›

Sharpening/Replacing mower blades (recommended every 25 hours or seasonally) Changing the oil (recommended every 50 hours of operation or seasonally) Changing the oil filter (recommended every 100 hours of operation or seasonally)

Lazer E and S Series units from 1250 hours to 2500 hours. Lazer X Series units from 1500 hours to 2500 hours. Radius E Series units from 500 hours to 750 hours. Radius S Series units from 750 hours to 1000 hours.

High-Performance Premium Hydro Oil | Exmark.

After 100 hours of operation, it is recommended that the hydraulic fluid in an average mower be checked. If the mower's oil is still in good condition, you can change it after 1000 hours of operation.

Starts becoming a reliability issue when it gets that old. Plus, you get somewhat of a trade in/bigger down payment toward a newer machine. We put on about 500 to 600 hours in one season. New2TheGreenIndustry: I would plan on a mower running 2,000 hours minimum.

If your zero-turn mower is used for commercial purposes or is particularly large, it will likely require more frequent maintenance than a smaller unit that's only used occasionally. Additionally, mowers with higher-quality parts and components typically last closer to the 15-year mark.

On average, a well-maintained zero-turn mower can last around 1,500 to 2,500 hours. However, it is important to note that these numbers can vary significantly. Quality, manufacturer, and specific model can also influence the longevity of a zero-turn mower.

Exmark/Scag sealed spindles will last hundreds if not thousands of hours. Like mentioned above, some of the serviceable spindles I've had apart had sealed bearings in them from the factory, so obviously putting grease in them won't do much.

Engines on most outdoor power equipment operate well with 5W30 Synthetic oil. For equipment operated in hot temperatures, Vanguard 15W50 Synthetic oil provides the best protection.

What oil should I use in my Exmark? ›

"SAE 30 / SAE 10W-30"

Whether your engine requires SAE 30 or SAE 10W-30, Exmark Premium performs like no other.

Fuel Capacity 7-gallon (26.5-L) single fuel tank with single fill location.

Exmark oil has a blue dye to it which makes it a lot easier to check the oil.

Hydraulic oil vs Transmission fluid

When comparing hydraulic oil and transmission fluid, it's important to note that hydraulic fluids are used for general power transmission in various machinery, while transmission fluids are specifically designed for transmissions in vehicles.

Together, these attributes result in a long-life fluid that truly holds up over time and extends equipment life. Recommended for all hydrostatic drive systems where the manufacturer recommends SAE 20W-50 fluid.

As a general rule of thumb, you should change your oil after 50 hours of use or at least once a year. Regular oil changes keep your lawn mower in top condition, ensuring it runs smoothly and lasts for years to come. With proper maintenance, you can keep your lawn looking great without any hassles.

When choosing lawn mower oil, use a high-quality detergent oil classified as "For Service SF, SG, SH, SJ" or higher. Do not use special additives. Synthetic oils are an acceptable oil at all temperatures. The use of synthetic oil does not alter required oil change intervals.

Taking proper care of your lawn mower will help your machine run well for years to come. One overlooked aspect in lawn mower maintenance is how frequent oil changes should take place. Engine oil and oil filters should be replaced at least once every spring or summer, or every 50 hours of use - whichever comes first.

After the first 5-10 hours of operation, the oil should be changed to remove asperities that have broken from the bearings of the engine components and cylinder wall. The break-in oil change can be performed using the recommended grades of standard or synthetic oil.